Time： 2017-06-10 16:24:51
With popularity in every household water purifiers, some problems also will ensue, large and small, small make up, and everyone talk about common water purification machine leakage causes and solutions of common leaking problem basically has the following kinds:
First,An improper installation, water purification machine, such as water purification machine to filter shell in the filter screw-top too tight or too loose, can cause the water leaked directly. Again, such as water purification machine and feed line connected without ribbons, water purification machines and pipe connecting to save space, etc., will result in water purification machine is leaking. Some manufacturers to reduce costs, the use of inferior materials, such as joint quality closes nevertheless, PE tube concentricity is not good, uneven thickness of tube wall, no pressure, no water hammer shock resistance may cause water purification machine is leaking.
Second, membrane shell burst, carbon leakage, water pressure is too high or low, water purifier water pressure is 0.1 mpa to 0.35 mpa, water pressure is too low will affect the water yield; Water pressure is too high will cause membrane damage, etc. Our common low voltage switch leakage, leakage activated carbon, activated carbon shell, ultrafiltration membrane shell burst are related to the water pressure is too large.
Solution: to install water purification machines, before installation, first of all, to measure the water pressure, make sure the water pressure within the scope of the use of the water purification machine, water pressure is too high, should communicate with the user, equipped with pressure reducing valve. Water pressure is too low to suggest users equipped with raised pressure pump.
Three, purification water effect is not obvious water purification machine water as required by the municipal tap water, if the filters the water processing does not accord with the requirement of water quality, will cause the phenomenon of water purification effect is not good. In the use of groundwater as water sources, of the older residential areas, water pipe and galvanized pipe, because the time is too long, galvanized pipe serious aging, rust, water turbidity. To meet the water quality situation, it is suggested that cannot be installed directly water purification machines, with coarse filtration method to remove the source of water and sediment, rust, etc. Otherwise the contamination and plugging water purification machines easily filter is caused the phenomenon of water or water purification effect is poor.
Solution: before installation to test the water pressure at the same time also want to test the water quality in water, if you don't accord with the requirement of water quality, to communicate with the user to suggest adding pre filter in front of the water purification machine. The water source for groundwater or if the user home use reservoir water, must be mounted to the front filter in front of the water purification machine.